The Solar-Powered direct water pump Kit is conveniently powered by energy from sunlight, no external batteries or electricity needed. The solar water pump has a Water output of 1500 L/Hr, can do 50 Meters pull depths (Best for up to 150 feet well/borehole). OTHER FEATURES: Can pump water from a river at 2000 l/hr with fairly sloppy area for 3 kilometers No need for battery and solar controller Can work with solar panels only (2 panels of 150 watts) Can pump water from fairly sloppy area to 3 Kilometers Horse pump 1.5 hp Does not need a controller Should NOT be used with inverter Can go dry without damage i.e no need for float switch Product has a life span of 15-20Years Solar-powered submersible pump suitable for wells and boreholes 4 inch diameter or larger. No need for solar charge controller, i.e. connect the two wires of the pump directly to solar panel. No need for float switch. The pump can run dry without damage. Profile This pump is best for small/Medium sale use i.e where water requirement is between 10,000 to 15,000 liters per day. Very good for irrigation.

The Total peripheral booster water pump 0.5HP is a robust, reliable and economical pump used principally for water transfer in domestic and small scale water transfer applications. The pump body is made from cast iron with a brass insert set into the front housing for improved starting performance and protection from jamming. The impeller is made from brass. The pumps have been remodeled and re-engineered offering the following benefits;

• Quiet operation due to the anti vibration system between shaft and impeller
• More compact
• More efficient motor with low energy consumption and lower operating temperature.
• Special paint which gives improved resistance against environmental corrosion
• Longer life

  Pumps can be installed for manual or automatic control using either the unique ‘Press control’ unit or a pressure tank and switch. Also available is the integral ‘Hydrofresh’ version which combines a 24L horizontal diaphragm tank, pressure switch and gauge with pressure settings of 1.4 Bar for pump start and 2.8 Bar for pump stop.

MOTOR

Pumps are close coupled to a TEFC brushless induction motor designed for continuous operation. A thermal relay is provided in the windings to protect against electrical and mechanical overload and the pump can be connected directly to the mains power supply through a 10amp fuse or MCB.